electronics engineering / servo + automation repair
Siemens Servo Motor Repair
Repairs + Reconditions of all Siemens Servo, Spindle, DC + AC Motors
Siemens Motor Disassembly
The moment an Siemens motor is recieved into our motor shop it is tagged + recorded so that you can track the
status of your repair. We then evalutate the motor by disassembling it to determine if any wear or damage can be seen on the motor. The alignments are recorded + archived for to future motors with extensive damage.
Siemens Shaft Seals + Bearing Replacement
Regardless of the original condition we replace the bearings + seals on your Siemens motor with the highest quality bearings + seals.
Siemens Servo Motor Testing
All Siemens motors repaired by ENA Electronics are run through a series of tests including, megger testing to test the insulation resistance, surge testing, ohm testing, + thermo testing.
The rotors are then tested for keyway damage, bent shaft, balancing + magnet strength on top of this the brakes are tested for damage + torque tested for manufacturers holding strength.
Siemens Encoder Testing
Feedbacks are tested for defects and errors. When approved, the motor is cleaned, all parts replaced, reassembled, aligned on our dynamic Mitchell feedback system.
Sealed Siemens Motors
Torque seals are added to our motors, + motors are epoxy painted with our custom paint formula, all connectors including the output shaft have protection added.
Back to Top